- Notes, Cautions, and Warnings
- Introduction
- Using Lifecycle Controller
- Operating System Deployment
- Monitor
- Hardware Inventory View and Export
- About View and Export Current Inventory
- About View and Export Factory-Shipped Inventory
- Viewing Hardware Inventory—Current or Factory-Shipped
- Exporting Hardware Inventory—Current or Factory-Shipped
- Viewing or Exporting Hardware Inventory After Part Replacement
- Viewing and Exporting Current Inventory After Resetting Lifecycle Controller
- Lifecycle Log
- Firmware Update
- Configure
- System Control Panel Access Options
- Configuring iDRAC
- Configuring System Time And Date
- Configuring vFlash SD Card
- Configuring RAID
- Configuring RAID Using Software RAID
- Creating a Secure Virtual Disk on Series 8 Controller
- Key Encryption
- Local Key Encryption Mode
- Breaking Mirrored Drives
- System Setup-Advanced Hardware Configuration
- Collect System Inventory on Restart
- Configuring Local FTP Server
- Configuring Local USB Drive
- Maintain
- Troubleshooting and Frequently Asked Questions
- Lifecycle Log Schema
- Easy-to-use System Component Names
- Using The System Setup and Boot Manager
Dell Lifecycle Controller 2 Release 1.4.0 User's Guide
What's New in this Release?
The new features for this release are:
- Added support for R220, FC420, FC620, R920, and FM120 servers.
- Support for the new operating systems. For a list of supported operating systems, contact your service provider.
- Support for the Emulex NICs: D6T93, RFPC9, YGW92, KYKT7, and JJPC0.
- Support for Samsung Solid State Drive (SSD).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\